Frequently Asked Questions - Internet

It is an abbreviation for asymmetric Internet connection, where the download speed is higher than the upload speed, and the service is connected via copper cables.

It is a lamp in the modem that lights up constantly when the modem is connected to the internet station

It is a light bulb in the modem that lights up when the modem is connected to the Internet.

The ADSL signal is an indicator of the modem’s successful connection to the Internet station, but you cannot surf the Internet. The Internet signal is an indicator of the modem's connection to the Internet, and here you can surf the Internet.

  • land line phone
  • Submit a request to enter the Internet service on the fixed phone from the nearest subscriber service center
  • Subscribing to an internet package, where packages start at a speed of 1 Mbps (1500 YER per month)
  • Internet modem
  • For more information about the service (Click here..)

  • The modem is not programmed correctly (correct settings VPI=8 VCI=35 protocol PPPoE-LLC username and password)
  • Expiry of credit or expiration of the subscription period

There are several reasons including:
  • Incorrectly connecting the telephone cord to the modem
  • There is a problem with the copper wire inside the subscriber's house
  • There is a problem with the electricity feeding the modem
  • There is a problem with the external copper wire

What is meant is connecting the modem wire to the phone port in the filter, and the correct one is connecting the wire to the ADSL port

The filter is a white piece used to separate sound from the Internet so that the subscriber can use the phone and the Internet at the same time. It has one input and two outputs.. one for the phone and one for the Internet.

Disconnect the main telephone wire from the filter entrance and connect it directly to the modem .. If the Internet works well, the problem is in the filter and you must replace it with a good one

First: The quality of the copper wire may be poor and the wire diameter is small (the diameter of the copper wire should not be less than 5 mm, but if the diameter of the wire is 2 mm, this causes weak Internet and cut off the ADSL signal)

Second: Connect the phone and the modem without a filter, or connect the phone before the filter. The black wire must be connected to the filter, then the phone and the Internet modem are connected after the filter.

Third: Pass the telephone wire next to the electricity, and it is correct not to pass the telephone wire next to any electrical device or electric wire

If the electrical current to the modem is unstable, it causes weak and cut off the ADSL signal, and if the battery voltage is low, it causes a problem with the quality of the Internet

It is the wire that connects from the central to the cabin to the splitter to the subscriber’s house.. If the wire is poorly installed in the cabin or the splitter, or there is moisture in the wire or a disconnection, this affects the quality of the Internet service. In this case, you should contact the technical support center 01331313

In the event that there is an ADSL signal and an Internet signal and there is no browsing, make sure that you have performed the following steps in succession:
  • Ensure that the connection between the computer and the modem is sound, through: If the connection is through a network cable, you must make sure that the network cable is connected correctly on both ends, and that the local network is activated. And if the connection is through a wireless network, It is necessary to make sure whether the network name has been changed recently, or there is an X on the network name. If so, the network name must be deleted, searched for and connected again.
  • Ensure that there is no proxy by selecting the Tools menu from the Internet browser, and then selecting Connections, including LAN settings, and then making sure that the proxy is not used.
  • Clear temporary internet files from the device, by selecting the Tools menu from the Internet browser and then selecting Delete temporary browsing files.
  • Check the modem settings.

Make sure you have done the following steps:
  • Make sure that the phone cord is plugged into the modem
  • Ensure that the filter is properly connected as follows: Ensure that the main telephone wire is connected to the filter in the phone port and that the modem wire is in the modem or DSL port or the computer image according to the type of filter. And making sure that the phone cord is in the Phone port or a phone image according to the type of filter, and making sure the filter is safe, by connecting the phone to the modem without a filter to test whether it works properly or not. If it works properly, the filter must be replaced in this case.
  • Perform the steps of the energy cycle as follows:
    • Turn off the modem.
    • Disconnect the telephone cord from the wall, from the modem, the network cable, and the power adapter cord.
    • Reconnect and turn on the modem and make sure the signal. If the previous steps do not work, you can contact the technical support staff at 01331313

Go to the service page to find all the details (Click here..)

  • Automatic hardware updates for systems and software and is turned off in the hardware settings
  • Watch and download videos continuously
  • Download large files
  • A large number of users on the same line
  • Modem hack

  • Write a password for the wireless network consisting of letters, numbers and symbols and change it every period
  • Hide the wireless network
  • Disable the wps vulnerability through the wireless settings of the modem

  • Difficulty connecting the user to the modem due to the presence of interference in the Wi-Fi signal from neighboring networks, and this is resolved by changing the wireless channel of the modem
  • Pass the telephone wire next to a working electrical device or electrical wire
  • Download files very quickly, which drags the speed on the rest of the users
  • Watch videos in high definition
  • There is a problem with the copper wire that causes poor internet

Through the value of the Internet signal SNR, if it is higher than 10, the line is good, and if it is less than 10, then there is a problem with the wire You can find out the value of SNR by entering the modem settings and going to STATUS or DEVICE INFO > ADSL

Through the following link: ADSL.YEMEN.NET.YE

Through the following link:SPEEDTEST.YEMEN.NET.YE

It is an internet service via optical fibers at high speeds starting from 16 megabytes and up to 40 megabytes. For more information about the service and subscription packages, visit the service page(Click here..)

Internet speeds start from 16 Mbps up to 40 Mbps

The subscriber can raise the speed and move from one package to another from any branch of subscriber services in the Republic.

If the number to which the service is to be transferred is within the same central range of the previous number, it can be transferred by requesting from subscriber services. But if the number to which the service is to be transferred is in another exchange, the subscriber must go to the subscriber services that the exchange follows for the line to be transferred to.

   Share: